Setting Vlan Link Type On Ethernet Interface; Adding Vlan Member Port - Zte ZXR10 5900 Series User Manual

Command
ZXR10(config-gei_1/x)#
|hybrid}
Command
ZXR10(config-gei_1/x)#
{<vlan-id>|<vlan-name>}
+ VLAN ID. VLAN ID includes four digits (0s are pretended when
there are less than four digits). Name of VLAN 4 is VLAN0004.
Setting VLAN Link Type on Ethernet
Interface
To set VLAN link type on Ethernet port, use the following command.
switchport mode {access|trunk
There are three VLAN link types for Ethernet interface of ZXR10
5900/5200: Access mode, Trunk mode and Hybrid mode. Access
mode is used by default.
� Ports of access mode belong to only one VLAN, support un-
tagged frames and are usually connected to computers.
� Ports of trunk mode can belong to several VLANs (re-
ceives/sends packets from/to several VLANs), support tagged
frames, and are usually used as trunk ports between switches.
� Ports of hybrid mode can belong to several VLANs (re-
ceives/sends packets from/to several VLANs), support both
tagged and untagged frames (customized), and can be used
to connect both switches and computers.
Ports of hybrid mode are different from trunk ports. They send
both tagged and untagged frames (trunk ports send untagged
frames only when they are from the default VLAN).

Adding VLAN Member Port

To add an access, trunk or hybrid port to a specified VLAN, use
following commands.
Access port only can be added to one VLAN, Trunk port and Hybrid
port can be added into multiple VLANs.
� To add an access port into a specific VLAN, use the following
commands.
switchport access vlan
� To add a trunk port to a specific VLAN, use the following com-
mand.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 1 VLAN Configuration
Function
This sets VLAN link type on
Ethernet port.
Function
This command adds an access
port to a specified VLAN.
7