Configuring Vlan; Creating Vlan; Creating A Vlan In Vlan Database; Setting Vlan Name - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Ethernet Switching Volume)
Command
vlan {<vlan-id>|<vlan-name>}
ZXR10(config)#
Command
vlan list <vlan-list>[name <vlan-name>]
ZXR10(config)#
Command
ZXR10(config-vlanX)#
6 Confidential and Proprietary Information of ZTE CORPORATION
gateway address. Even if there are a number of idle IP addresses
in a user's subnet, they cannot be allocated to other users. This
causes waste of IP addresses.
SuperVLAN effectively resolves this problem. It merges several
VLANs (called sub-VLAN) to a SuperVLAN so that they can use the
same IP subnet and default gateway.
With the SuperVLAN technology, the ISP needs only one IP sub-
net for its SuperVLAN. It creates a sub-VLAN for each of its users.
These sub-VLANs can use flexibly the IP addresses in the Super-
VLAN subnet and share the default gateway of the SuperVLAN.
Each sub-VLAN is an independent broadcast domain, ensuring user
isolation, and communicates with other sub-VLANs through Super-
VLAN routing.

Configuring VLAN

Creating VLAN

Creating a VLAN in VLAN Database

To create a VLAN in VLAN database, use the following command.

Setting VLAN Name

To set VLAN name, use the following command.
name <vlan-name>
VLAN name uniquely identifies a VLAN. This can be a group, de-
partment and region name. By default, a VLAN name is "VLAN"
Function
This creates specific VLAN and
enters into VLAN configuration
mode.
Function
This creates a VLAN in VLAN
database.
Function
This sets VLAN name.