Configuring Zess Control Vlan; Configuring Zess Port - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Ethernet Switching Volume)
Parameter
< 1-4>
revertive | non_revertive
Example
Step Command
1
ZXR10(config)#
2
ZXR10(config)#
Parameter
< 1-4>
< 1-4094>
Example
Step Command
1
ZXR10(config-gei_1/x)#
2
ZXR10(config-gei_1/x)#
<1-4094>
84 Confidential and Proprietary Information of ZTE CORPORATION
Description
Domain ID, it indicates ZESS domain.
inversion or non-inversion modes, In inversion mode, when
main link recovers, service will be cut again, whereas in
non-inversion mode, service will still be transmitted on
standby link.
Configure ZESS node that domain is 1 and in non-inversion mode.
ZXR10(config)# zess domain 1 mode non_revertive

Configuring ZESS Control VLAN

ZESS node can send flush packet to upper node for cleaning FDB.
zess domain <1-4> ctl-vlan <1-4094>
no zess domain <1-4> ctl-vlan
Parameter Description:
Description
Domain ID, it indicates ZESS domain.
Control vlan Id, it is used to send flush packet which is
multicast in this vlan.
1. Configure domain 1 control vlan as 2000.
ZXR10(config)#zess domain 1 ctl-vlan 2000
2. Deletes domain 1 control vlan.
ZXR10(config)#no zesr domain 1 ctl-vlan

Configuring ZESS Port

To configure the designated port as ZESS packet receiving port,
use the following command. This command must be carried out
in the corresponding port mode.
zess receive-vlan <1-4094>
no zess receive-vlan
Function
This configures ZESS ctl-vlan.
This deletes ZESS control
VLAN.
Function
This adds port into ZESS
VLAN receiving table.
This deletes port from ZESS
VLAN receiving table.