Cfm Configuration; Cfm Overview - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Ethernet Switching Volume)
94 Confidential and Proprietary Information of ZTE CORPORATION
Local DTE
-----------
Config:
Mode : active
Period : 10*100(ms)
Link TimeOut : 3(s)
Unidirection : nonsupport
PDU max size : 1518
Status:
Parser : forward
Multiplexer : forward
Stable : yes
Discovery : done
Loopback : off
PDU Revision : 0
Remote DTE
-----------
Config:
Mode
Link Monitor
Unidirection
Remote Loopback : support
Mib Retrieval
PDU max size
Status:
Parser
Multiplexer
Stable
Mac Address
PDU Revision

CFM Configuration

CFM Overview

Connectivity Fault Management (CFM) is useful to Virtual Bridged
Local Area Networks for detecting, isolating, and reporting connec-
tivity faults. It is aimed primarily at Provider Bridged Networks,
but is useful also for C-VLAN networks.
CFM that current switch mainly supports implementation based on
IEEE 802.1ag.
The manager of network plans the network service and divides the
whole network into multiple MDs for management and diagnosis,
single domain is as shown in
The domain in the figure defines a series of ports on edge de-
vice and internal device. The gray point on the edge device is
service port that connects the devices out of domain, which is
defined maintenance edge point (MEP). The black port (includes
those devices on the domain intermediate device) is the port that
connects devices in the domain, which is defined as maintenance
intermediate pointMIP. Implement domain management function
by defining MEP and MEP.
: passive
: support
: nonsupport
: nonsupport
: 1518
: forward
: forward
: yes
: 00.19.c6.00.2b.fc
: 1
Figure 26.