Command
sflow { enable | disable}
ZXR10(config)#
Step Command
1
sflow agent-config ipv4-address
ZXR10(config)#
A.B.C.D [udp_port]
2
sflow agent-config ipv6-address
ZXR10(config)#
X:X::X:X [udp_port]
Step Command
1
sflow collector-config ipv4-address
ZXR10(config)#
A.B.C.D [udp_port]
2
sflow collector-config ipv6-address
ZXR10(config)#
X:X::X:X [udp_port]
Command
ZXR10(config-gei_1/x)#
egress}<ratevalue>
Configuring sFlow
1. To enable/disable sflow module, use the following command.
2. To configure sflow Agent, use the following command.
3. To configure sFlow Collector, use the following command.
4. To configure sFlow sampling rate, use the following command.
sflow-sample-rate { ingress|
SFlow Configuration
Example
The networking figure is as shown in
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 Sflow Configuration
Function
This enables/disables sflow
module.
Function
This configures sFlow Agent
IP address.
This configures sFlow Agent
IPv6 address.
Function
This configures sFlow
Collector IP address.
This configures sFlow
Collector IPv6 address.
Function
This configures sFlow sampling
rate on the interface.
Figure
21.
77