Cfm Function Configuration - Zte ZXR10 5900 Series User Manual

Step Command
18
ZXR10(config-md-ma)#
<interfacename>
19
ZXR10(config-md-ma)#
20
ZXR10(config-md-ma)#
21
ZXR10(config-md-ma)#
able}
22
ZXR10(config-md-ma)#
<1-5>
23
ZXR10(config-md-ma)#
24
ZXR10(config-md-ma)#
{enable|disable}
25
ZXR10(config-md-ma)#
able|disable}
Command
cfm lbm md <1-16> ma <1-32> smep-id
ZXR10#
<1-8191>{(dmep-id <1-8191>) | (dmep-mac<xxxx.x
xxx.xxxx>) |(dmip-mac <xxxx.xxxx.xxxx>)}[{[repeat
<1-200>],[size<1-400>],[timeout<1-10>]}]
assign mip <1-64> interface
no assign mep <1-8191>
no assign mip <1-64>
mep<1-8191>state{enable|dis
mep<1-8191>alarm-lowest-pri
mep<1-8191>priority <0-7>
mep<1-8191>ccm-send
mep<1-8191>ccm-check{en

CFM Function Configuration

1. To enable LB function, use the following command.
LB (LoopBack) means a MEP sends a designated MP unicast
CFM PDU for fault affirmation and isolation. A MP responses
LBM and sends unicast packet to LBM initiator MEP.
When MP loop responser receives a LBM, check its validity
first, if invalid then discard. If LBM source address is multi-
cast address (not alone MAC address) or destination address
and receiving MP MAC aren't matching, MP discards this LBM
packet. If test succeeds, receiving MP sends a LBR to MEP that
lauches LBM by taking LBM source address as destination ad-
dress. When a LBR is received by MHF, ignore this LBR for the
reason that MIP hasn't the entity that receiving LBR.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 11 Ethernet OAM Configuration
Function
This assigns MIP to port.
the port can be samartgroup.
When assigning port for MIP,
the MEP that level is higher
than or equal to current MIP
level can't exist on the port in
the same vlan same level.
This cancels the assignment
of MEP to port.
This cancels the assignment
of MIP to port.
This sets MEP management
enabled.
This sets MEP alarm priority.
The five priorities from low
to high are RDI alarm, MAC
alarm, RMEP CCM failure
alarm, ERR CCM alarm and
XCON alarm.
This sets MEP priority.
This sets CC packet sending
enabled.
OAM board needn't enabled,
CC will be sent automatically
as long as global enabled.
This checks CC packet.
Function
This enables LB function.
99