Dot1P Commands; Classofservice Dot1Pmapping; Show Classofservice Dot1Pmapping; Vlan Port Priority All - Planet Networking & Communication WGS3-2820 User Manual

8.3 Dot1P Commands

8.3.1 classofservice dot1pmapping

This command maps an 802.1p priority to an internal traffic class for a device when in 'Global Config' mode. The number of
available traffic classes may vary with the platform. Userpriority and trafficclass can both be the range from 0-7. The command
is only available on platforms that support priority to traffic class mapping on a 'per-port' basis, and the number of available
traffic classes may vary with the platform.
▫
Format classofservice dot1pmapping <userpriority> <trafficclass>
▫
Mode Global Config or Interface Config

8.3.2 show classofservice dot1pmapping

This command displays the current 802.1p priority mapping to internal traffic classes for a specific interface. The slot/port
parameter is required on platforms that support priority to traffic class mapping on a 'per-port' basis.
Platforms that support priority to traffic class mapping on a per-port basis:
▫
Format show classofservice dot1pmapping <slot/port>
Platforms that do not support priority to traffic class mapping on a per-port basis:
▫
Format show classofservice dot1pmapping
▫
Mode Privileged EXEC and User EXEC

8.3.3 vlan port priority all

This command configures the port priority assigned for untagged packets for all ports presently plugged into the device. The
range for the priority is 0-7. Any subsequent per port configuration will override this configuration setting.
▫
Format vlan port priority all <priority>
▫
Mode Global Config

8.3.4 vlan priority

This command configures the default 802.1p port priority assigned for untagged packets for a specific interface. The range for
the priority is 0-7
▫ 0
Default
▫
Format vlan priority <priority>
▫
Mode Interface Config

8.4 LAG/Port-Channel (802.3ad) Commands

8.4.1 port-channel staticcapability

This command enables the support of port-channels (static link aggregations - LAGs) on the device. By default, the static
capability for all port-channels is disabled.
▫ Disabled
Default
▫
Format port-channel staticcapability
▫
Mode Global Config
User's Manual of WGS3-2820/WGS3-5220
334