Frame Format - Panasonic DBS-576 Technical Manual

FF2: Trunk Programming (T1 CO)
Notes:
Introduction
If CO is set to Immediate Start, system will wait this long before recognizing ring from CO.
This setting is available only if the Trunk Signal Type is set for "2" (DID Immediate Start) or "3" (DID
Wink Start); it is not available for Loop Start or Ground Start signaling types.
0
System
Configuration
Related Programming:
Trunk Signal Type (pg. 2-87)
FF1
System
Not Used
FF2
(all CPCs) - Version 1.0 or higher
Trunks
FF2 2 BSSCC
FF3
Extensions
FF4
FF-/Soft Keys

Frame Format

(all CPCs) - Version 1.0 or higher
FF5
Set the framing format ordered from the CO (assign to Channel #1).
Groups
FF6
TRS/ARS
BSSCC: T1 (CO) Channel Position ("01" only)
FF7
Applications
Notes:
This setting is available only for Channel 01.
FF8
"SF" stands for SuperFrame (also known as D4), in which sampling frames are transmitted in groups of
Maintenance
12.
"ESF" stands for Extended SuperFrame, in which sampling frames are transmitted in groups of 24. ESF
provides monitoring and maintenance capabilities that aren't available with SF.
Both "SF" and "ESF" use robbed-bit signaling, in which the 8th bit is robbed from every 6th frame to
Appendix A
transmit signaling states such as On-Hook and Off-Hook.
Appendix B
Page 2-90
FF2 2 BSSCC 02 00 Hold (0-3) Hold
02 05 Hold
FF2 2 BSSCC
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01
DBS 576 (USA) issued 05/20/98
02 06 Hold (0 or 1) Hold
0=SF (default)
1=ESF
Section 400-Programming
$
)! B
$ 
" "!
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B