Panasonic DBS-576 Technical Manual page 264

FF2: Trunk Programming (Analog CO)
Notes:
Introduction
While the trunk is guarded, it cannot be used for another call until this Guard Timer has expired.
This setting is available only if the Trunk Signal Type is set for "0" (Loop Start) or "1" (Ground Start);
it is not available for DID signaling types.
0
System
Configuration
Related Programming:
Trunk Signal Type (pg. 2-8)
FF1
System
Inbound Ground Detect Timer
(all CPCs) - Version 1.0 or higher
FF2
Set how long a CO Tip-ground signal must be present on a Ground Start trunk,
Trunks
before the system recognizes it as a valid incoming call.
FF3
Extensions
FF4
FF-/Soft Keys
Notes:
FF5
If this Inbound Ground Detect Timer is set too short, the system may generate false ringing when Tip-
ground is not removed quickly enough at the end of the call.
Groups
Related Programming:
FF6
Trunk Signal Type (pg. 2-8)
TRS/ARS
FF7
Applications Not Used
(all CPCs) - Version 1.0 or higher
FF8
Maintenance
Appendix A
Appendix B
Page 2-16
FF2 0 BSSC 01 00 Hold (0-3) Hold
FF2 0 BSSC
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2 0 BSSC 01 00 Hold (0-3) Hold
FF2 0 BSSC
DBS 576 (USA) issued 05/20/98
01 17 Hold (0-3) Hold
0=1 second (default)
1=2 seconds
2=4 seconds
3=8 seconds
01 18 Hold
Section 400-Programming
$ %
1!- #%1 %
$ 
)! B
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B