Panasonic DBS-576 Technical Manual page 353

Section 400-Programming
Introduction
Indirect LCR
(all CPCs) - Version 1.0 or higher
(U.K. use only) Enable/Disable the Indirect Least Cost Routing (LCR) function.
0
System
Configuration
FF1
BSSCC: T1 (CO) Channel Position
System
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
FF2
Notes:
Trunks
Indirect LCR: System will send a pre-assigned code (set in the ARS Dial Conversion Tables) when an
extension seizes the trunk to make an outgoing call. This feature is used in the U.K. for sending a
system identification PIN number to the CO.
FF3
Extensions
U.S.A.: Do not enable this address for MCO access code routing (eg., dialing "9" to get an outside line).
Instead, use ARS tables (see FF6) so the system can distinguish intercom calls from outgoing calls.
FF4
Related Programming:
FF-/Soft Keys
FF6 2 05: Digit Modify Table (pg. 6-38)
FF5
Groups
Call Duration
(all CPCs) - Version 1.0 or higher
FF6
Set whether the system will use the Call Duration Timer to begin tracking call duration
TRS/ARS
(both on LCD display and in SMDR records) for an outgoing call on this trunk.
FF7
Applications
FF8
Maintenance
Notes:
This address should be set to "0" (Do not use system timer) if the CO sends back reverse signaling for
called-party answer (typical in the U.K.).
Appendix A
Appendix B
576-13-400
FF2 2 BSSCC
FF2 2 BSSCC
BSSCC: T1 (CO) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
DBS 576 (USA) issued 05/20/98
03 15 Hold (0 or 1) Hold
0=Disable Indirect LCR. (default)
1=Enable Indirect LCR.
03 16 Hold (0 or 1) Hold
0=Do not use system timer to
1=Use system timer to start
FF2: Trunk Programming (T1 CO)
$
 ' 5
$ 
,, -!
start call duration.
call duration. (default)
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 2-105