Panasonic DBS-576 Technical Manual page 269

Section 400-Programming
Introduction
CO Dial Tone Simulation
(all CPCs) - Version 1.0 or higher
Set whether the system sends a simulated CO dial tone to an extension using this trunk
0 (important for DID Wink-Start trunk signaling).
System
Configuration
FF1
System BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2
Trunks
Notes:
Set to "1" (Send) if the CO doesn't support dial tone (typical in U.K.).
FF3
Related Programming:
Extensions
Trunk Signal Type (pg. 2-8)
FF4
FF-/Soft Keys
Caller ID Ring Control
(all CPCs) - Version 1.0 or higher
Set whether the system will wait for Caller ID information before ringing an
FF5
incoming call on this trunk; or whether ringing will commence immediately.
Groups
FF6
TRS/ARS
BSSC: Analog (CO) Trunk Position
FF7
Applications
Notes:
FF8
The trunk must be enabled for Caller ID (in FF2 0 BSSC 01 10) in order for this address to take effect.
Maintenance
Related Programming:
Caller ID (pg. 2-12)
Appendix A
Appendix B
576-13-400
FF2 0 BSSC
FF2 0 BSSC 01 00 Hold (0-3) Hold
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2 0 BSSC 01 10 Hold (0 or 1) Hold
DBS 576 (USA) issued 05/20/98
FF2: Trunk Programming (Analog CO)
02 07 Hold (0 or 1) Hold
0=Do not send simulated CO dial tone
to extension. (default)
1=Send simulated CO dial tone.
02 08 Hold (0 or 1) Hold
0=Wait for Caller ID data. (default)
1=Immediate ring (do not wait).
Introduction
$ %
# %
0
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
$ 
)2 !!,
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 2-21
System