Flash Key Operation - Panasonic DBS-576 Technical Manual

Section 400-Programming
Introduction
SMDR for Inbound Calls
(all CPCs) - Version 1.0 or higher
Set whether incoming calls on the T1 channel will be included in SMDR records.
0
System
Configuration
FF1
BSSCC: T1 (CO) Channel Position
B=Cabinet no. 1-6
System
SS=Slot no. 01-12
CC=Channel no. 01-24
FF2
Notes:
Trunks
FF3 Related Programming:
Extensions
SMDR Data to Serial Port (pg. 1-88)
SMDR Output Format (pg. 1-93)
FF4
FF-/Soft Keys

Flash Key Operation

(all CPCs) - Version 1.0 or higher
Set what happens when a digital phone user presses the FLASH, PROG or
FF5
Recall key during a call on this T1 channel.
Groups
FF6
TRS/ARS
BSSCC: T1 (CO) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
FF7
CC=Channel no. 01-24
Applications
Notes:
The sending of the flash signal can also be enabled/disabled on individual extensions (see Flash-Signal
FF8
Control on pg. 3-19).
Maintenance
If the flash signal is disabled on the trunk but enabled on the extension (or vice versa), a flash signal
will be sent when the user accesses the trunk and presses FLASH.
(all CPCs - Version 1.3 and higher)
also apply to an FF-key programmed for the SLT Flash Send feature (765 by default). See Dial Plans A
and B on pg. 1-155.
Appendix A
Appendix B
576-13-400
FF2 2 BSSCC
FF1 0 06 0001 Hold (0-2) Hold
FF1 0 09 0001 Hold (0-2) Hold
FF2 2 BSSCC
If this address is set to 0=Flash signal is sent to CO (default), it will
DBS 576 (USA) issued 05/20/98
03 08 Hold (0 or 1) Hold
0=Do not include in SMDR. (default)
1=Include in SMDR.
03 09 Hold (0 or 1) Hold
0=Flash signal is sent to CO. (default)
1=T1 channel is released, then user hears
internal dial tone.
FF2: Trunk Programming (T1 CO)
$ 
2  #-6-0 
$ &
",9 !!,
Page 2-101
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B