Panasonic DBS-576 Technical Manual page 379

Section 400-Programming
Introduction
DTMF Conversion (Inbound Calls)
(all CPCs) - Version 1.0 or higher
Set whether the T1 channel will switch from dial-pulse to DTMF signaling
0
after the extension user answers an incoming call.
System
Configuration
FF1
System
BSSCC: T1 (E&M Tie) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
FF2
Trunks
Notes:
FF3
Extensions Related Programming:
DTMF/Dial Pulse Dialing (pg. 2-125)
FF4
FF-/Soft Keys
Indirect LCR
(all CPCs) - Version 1.0 or higher
FF5 (U.K. use only) Enable/Disable the Indirect Least Cost Routing (LCR)
function on the T1 channel.
Groups
FF6
TRS/ARS
BSSCC: T1 (E&M Tie) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
FF7
CC=Channel no. 01-24
Applications
Notes:
Indirect LCR: System will send a pre-assigned code (set in the ARS Dial Conversion Tables) when an
FF8
extension seizes the trunk to make an outgoing call. This feature is used in the U.K. for sending a
Maintenance
system identification PIN number to the CO.
U.S.A.: Do not enable this address for MCO access code routing (eg., dialing "9" to get an outside line).
Instead, use ARS tables (see FF6) so the system can distinguish intercom calls from outgoing calls.
Appendix A
Related Programming:
FF6 2 05: Digit Modify Table (pg. 6-38)
Appendix B
576-13-400
FF2 2 BSSCC
FF2 2 BSSCC
DBS 576 (USA) issued 05/20/98
03 14 Hold (0 or 1) Hold
0=Do not switch to DTMF signaling.
1=Switch to DTMF signaling after the
extension user answers. (default)
FF2 2 BSSCC 03 00 Hold (0 or 1) Hold
03 15 Hold
FF2: Trunk Programming (T1 E&M Tie)
$ 
$7 !(0 
$
 ' 5
(0 or 1) Hold
0=Disable Indirect LCR. (default)
1=Enable Indirect LCR.
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 2-131