Software Upgrade Procedure For Cpc - Panasonic DBS-576 Technical Manual

Introduction to DBS 576 Programming

Software Upgrade Procedure for CPC-576

Introduction
1. Power-off the system.
2. Remove the old PC Card from the CPC-576,
0
System
Configuration
3. On the CPC card, press and hold down the
FF1
System
4. Wait until the RUN (top two) LEDs blink
FF2
Trunks
5. On the CPC card, press the RESET button.
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Intro-12
and insert the new PC Card.
MODE button, then power-on the system.
Keep holding the MODE button down until
the "MN" LED starts flashing red.
continuously and the bottom two (MJ and
MN) LEDs remain extinguished.
On installed display phones, "Welcome to
DBS" should display on the top line.
After a few seconds, the system will shut
off, then power-on automatically.
"INITIALIZING" will briefly appear on
one of the installed display phones while
the system resets itself.
The CPC LEDs should return to normal
(top two LEDs blinking continuously;
bottom two LEDs off).
All installed display phones should show
the normal, main menu:


DBS 576 (USA) issued 05/20/98
00:07 Wed JAN 01
100 EXT100
  
 
  

 

  

    
Section 400-Programming
The CPC-576 Card
(front edge, facing out from cabinet)
RUN LED (FPU)
RUN LED (MPU)
MJ LED
MN LED
RESET button
CODE rotary switch
MODE button
RAM HOLD switch
MOH plug-in
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B