Panasonic DBS-576 Technical Manual page 260

FF2: Trunk Programming (Analog CO)
Introduction
Caller ID
(all CPCs) - Version 1.0 or higher
Enable/Disable the Caller ID feature on this trunk.
0
System
Configuration
BSSC: Analog (CO) Trunk Position
FF1
System
FF2
Notes:
Trunks
To install Caller ID:
(1) Throw switches on the LTRK/8 (Loop-Start Trunk/8-port) Card.
FF3 (2) Install the CID Card (daughter board, mounted on the LTRK/8 Card).
Extensions
(3) Set this parameter.
See Section 300-Installation for more information.
Related Programming:
FF4
Caller ID Ring Control (pg. 2-21)
FF-/Soft Keys
FF5
Ring Frequency
Groups
(all CPCs) - Version 1.0 or higher
(digital phones only) Set the ring frequency for incoming calls on this trunk.
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Notes:
If "0" (Melody) is selected, you must set the next address to "12" (Continuous Tone). Otherwise, the
Ring Pattern will interrupt the melody heard.
Appendix A
Related Programming:
Appendix B
Page 2-12
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2 0 BSSC 02 08 Hold (0 or 1) Hold
FF2 0 BSSC
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
DBS 576 (USA) issued 05/20/98
01 10 Hold (0 or 1) Hold
0=Disable Caller ID. (default)
1=Enable Caller ID.
01 11 Hold (0-6) Hold
0=Melody
1=400/562 Hz (default)
2=1000/1340 Hz
3=400 Hz
4=800/1040 Hz
5=1040/1320 Hz
6=660/1320 Hz
Section 400-Programming
$
 !!,
$
 "F-'
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B