Panasonic DBS-576 Technical Manual page 287

Section 400-Programming
Introduction
Ring Detect Timer
(all CPCs) - Version 1.0 or higher
Set the amount of time allowed for the system to recognize an incoming call on
0
an E&M tie trunk set for Immediate Start signaling (see Trunk Signal Type).
System
Configuration
FF1
System
FF2
Trunks
Notes:
FF3
Related Programming:
Extensions
Trunk Signal Type (pg. 2-38)
FF4
FF-/Soft Keys
Auto Answer for Outbound Calls
(all CPCs) - Version 1.0 or higher
Set whether the system will automatically assume that an outgoing call on this
FF5
trunk has been answered by the other end, without waiting for an answer signal.
Groups
FF6
TRS/ARS
BSSC: E&M Tie Trunk Position
FF7
Applications
Notes:
FF8
Set this to "1" (Enable) only if the other system does not send back an answer signal (typically, it does),
Maintenance
or if the trunk is used for paging calls.
Related Programming:
Auto Answer Timer (pg. 2-45)
Appendix A
Appendix B
576-13-400
FF2 0 BSSC
BSSC: E&M Tie Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2 0 BSSC 01 00 Hold (0-5) Hold
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2 0 BSSC 01 18 Hold (0-3) Hold
DBS 576 (USA) issued 05/20/98
FF2: Trunk Programming (Analog E&M Tie)
01 05 Hold (0 or 1) Hold
0=48 ms (default)
1=160 ms
01 06 Hold (0 or 1) Hold
0=Disable Auto Answer; wait for answer
signal from other end, before opening
voice path. (default)
1=Enable Auto Answer; open voice path
without waiting for answer signal.
Introduction
$
 *% %
0
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
$ 
/-! ' /)
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 2-39
System