Panasonic DBS-576 Technical Manual page 318

FF2: Trunk Programming (ISDN)
Introduction
Indirect LCR
(all CPCs) - Version 1.0 or higher
(U.K. use only) Enable/Disable the Indirect Least Cost Routing (LCR) function on
0
the ISDN trunk.
System
Configuration
FF1
System
BSSC: ISDN Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4 (BRI)
FF2
Trunks
Notes:
FF3 Indirect LCR: System will send a pre-assigned code (set in the ARS Dial Conversion Tables) when an
extension seizes the trunk to make an outgoing call. This feature is used in the U.K. for sending a
Extensions
system identification PIN number to the CO.
U.S.A.: Do not enable this address for MCO access code routing (eg., dialing "9" to get an outside line).
Instead, use ARS tables (see FF6) so the system can distinguish intercom calls from outgoing calls.
FF4
FF-/Soft Keys
Related Programming:
FF6 2 05: Digit Modify Table (pg. 6-38)
FF5
Groups
B-Channel Select
FF6
TRS/ARS
(all CPCs) - Version 1.0 or higher
Set the method used by the system to seize a B-channel for an outgoing call.
FF7
Applications
BSSC: ISDN Trunk Position
FF8
Maintenance
Notes:
Appendix A
Set this address to the opposite of the CO's method, to prevent "glare" (when the same channel is
simultaneously seized by the CO for an incoming call, and by the system for an outgoing call).
Appendix B
Page 2-70
FF2 1 BSSC
or 1 (PRI)
FF2 1 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4 (BRI)
or 1 (PRI)
DBS 576 (USA) issued 05/20/98
03 08 Hold (0 or 1) Hold
0=Disable Indirect LCR. (default)
1=Enable Indirect LCR.
03 09 Hold (0 or 1) Hold
0=System will select the highest-numbered
channel. (default)
1=System will select the lowest-numbered channel.
Section 400-Programming
$ 
 ' 5
$ &
7'9 ,'
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B