Ff1 0 04: Trunk Cos Definitions; Table 1-3. Trunk Cos Addresses And Defaults - Panasonic DBS-576 Technical Manual

Section 400-Programming
Introduction

FF1 0 04: Trunk COS Definitions

NOTE: The following Trunk Class of Service (COS) addresses apply to all
0 trunk types: analog CO trunks, E&M tie lines, T1-CO, T1-E&M, and T-point
System
ISDN.
Configuration
When you enter the address number 00-15 for the desired COS No. 01-16, the
actual COS No. (01-16) will appear on the phone's display.
FF1
System
By default, all trunks are assigned to Trunk COS No. 1 (see FF2 Trunk COS
Assignment addresses for each trunk type).
FF2

Table 1-3. Trunk COS addresses and defaults

Trunks
FF1 0 04 (00-15) 01 Hold (0 or 1) Hold
FF1 0 04 (00-15) 02 Hold (0 or 1) Hold
FF3
FF1 0 04 (00-15) 03 Hold (0 or 1) Hold
Extensions
FF1 0 04 (00-15) 04 Hold (0 or 1) Hold
FF1 0 04 (00-15) 05 Hold (0 or 1) Hold
FF1 0 04 (00-15) 06 Hold (0 or 1) Hold
FF4
FF-/Soft Keys
Trunk COS: Incoming Ring Tone Source
FF5
(all CPCs) - Version 1.0 or higher
Groups
Set ring tone source for incoming calls on trunks in this Class of Service.
EXCEPTION: This address does not apply to E&M tie-trunks (analog or T1).
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Notes:
Appendix A
Intercom Ring Tone: Two short beeps, followed by 3 seconds of silence. Heard when direct calls are
ringing the phone; the "EXT" intercom LED (next to the FLASH key) will light.
Appendix B
576-13-400
Trunk COS: Incoming Ring Tone Source
Trunk COS: Dial Tone to Tie-Line
Trunk COS: Fast-Busy Tone to Tie-Line
Trunk COS: DID/DNIS Table
Trunk COS: Paging on DISA/Tie-Line Call
Trunk COS: DISA ID Verification
FF1 0 04 (00-15) 01 Hold (0 or 1) Hold
Trunk COS Nos. 1-16
00=COS 1 08=COS 9
01=COS 2 09=COS 10
02=COS 3 10=COS 11
03=COS 4 11=COS 12
04=COS 5 12=COS 13
05=COS 6 13=COS 14
06=COS 7 14=COS 15
07=COS 8 15=COS 16
DBS 576 (USA) issued 05/20/98
FF1: System Programming
0 (use trunk's
Ring Pattern)
1 (Enabled)
0 (Enabled)
0 ("A" side)
1 (Allowed)
0 (Verify)
0=Use the trunk's Ring Pattern setting
for all incoming calls. (default)
1=Use intercom ring tone for all incoming
calls except for multiple-incoming
(which will use the Ring Pattern setting).
Introduction
0
Configuration
FF1
System
FF2
Trunks
pg. 1-75
pg. 1-76
FF3
pg. 1-77
Extensions
pg. 1-77
pg. 1-78
pg. 1-79
FF4
FF-/Soft Keys
)) %!
FF5
<))=#   >
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 1-75
System