System board components
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
10.2.3 Replacing the UFM
Field Replaceable Units (FRU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
10.2.3.1 Required tools
Preliminary and concluding steps:
●
– combination pliers and flat nose pliers
Replacing the UFM:
●
– Phillips PH0 / (+) No. 0 screw driver
10.2.3.2 Preliminary steps
Before replacing the UFM, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server blade as described in section
defective server blade" on page
Ê Shut down the server blade as described in section
server blade" on page
246
73.
53.
54.
Upgrade and Maintenance Manual
99.
74.
45.
"Enabling
"Disabling BitLocker
"Disabling boot
"Opening the rack
"Locating the
"Shutting down the
BX924 S3