Removing An Ssd Module; Installing An Ssd Module; Concluding Steps - Fujitsu PRIMERGY BX924 S3 Upgrade And Maintenance Manual

Ê Locate the defective SSD module as described in section
defective component" on page
Only applicable for removing intact SSD modules:
Ê Before removing a non-defective SSD module, put the drive into "Offline"
mode using your RAID configuration software.
6.5.3

Removing an SSD module

Ê Remove the SSD module to be replaced from the server as described in
section "Removing SSD 0" on page
6.5.4

Installing an SSD module

Ê Install the new SSD module into the empty drive bay as described in section
"Installing SSD 0" on page
6.5.5

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 61.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
BX924 S3
50.
109.
67.
100.
Upgrade and Maintenance Manual
117.
"Closing the server blade" on
99.
Solid state drives
"Locating the
62.
"Closing the rack
"Performing a RAID
"Enabling
123