Removing A Mezzanine Card; Installing A Mezzanine Card; Concluding Steps - Fujitsu PRIMERGY BX924 S3 Upgrade And Maintenance Manual

Ê Shut down the defective server blade as described in section
the server blade" on page
Ê Locate the defective mezzanine card using the onboard Local Diagnostic
LEDs as described in section
page 284.
7.4.3

Removing a mezzanine card

Ê Remove the defective mezzanine card as described in section
mezzanine card" on page
7.4.4

Installing a mezzanine card

Ê Install the new mezzanine card as described in section
mezzanine card" on page
7.4.5

Concluding steps

I
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller
(expansion card or onboard CNA). For further information, please refer
to section "Note on network settings recovery" on page
Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page 61.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Enable the PCI slot of the replaced mezzanine card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 100.
BX924 S3
54.
"Onboard indicators and controls" on
149.
143.
67.
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
Mezzanine cards
"Shutting down
"Removing a
"Installing a
152.
"Closing the server blade" on
62.
"Closing the rack
93.
153