Table of Contents
Advertisement
6
Solid state drives
Safety notes
V
CAUTION!
The drive must not be removed from the installation frame by anyone
●
except a service technician.
Drive modules must all be marked clearly so that they can be
●
reinstalled into their original mounting locations after an upgrade.
Otherwise, data may be lost.
Do not touch the circuitry on boards or soldered parts. Hold the
●
metallic areas or the edges of the circuit boards.
Depending on the OS, you can configure the write cache settings for
●
the drives. If a power failure should occur while the write cache is
enabled, cached data may be lost.
When disposing of, transferring, or returning a hard disk or solid state
●
drive, wipe out the data on the drive for your own security.
Rough handling of drives may damage the stored data. To cope with
●
any unexpected problems, always back up important data. When
backing up data to another hard disk drive, you should make backups
on a file or partition basis.
Do not use the device in extremely hot or cold locations, or locations
●
with extreme temperature changes.
Never attempt to disassemble a hard disk or solid state drive.
●
For further safety information, please refer to chapter
●
information" on page
6.1
Basic information
– Solid state drives (SSDs) are the only type of drive to be installed in the
PRIMERGY BX924 S3 server blade.
– Solid state drives with different capacities are installed from highest to lowest
capacity.
– No mix of different bus technologies (SAS or SATA) is allowed.
BX924 S3
31.
Upgrade and Maintenance Manual
"Important
105
Advertisement
Table of Contents
