6.3
Installing SSD modules
Upgrade and Repair Units (URU)
Average task duration: 15 minutes
6.3.1
Required tools
Preliminary and concluding steps: tool-less
●
Installing an SSD module:
●
– Phillips PH2 / (+) No. 2 screw driver
6.3.2
Preliminary steps
Before installing an SSD module, perform the following steps:
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server blade as described in section
defective server blade" on page
Ê Shut down the server blade as described in section
server blade" on page
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page
Ê Open the server blade as described in section
on page
60.
BX924 S3
53.
54.
Upgrade and Maintenance Manual
45.
"Opening the server blade"
Solid state drives
"Opening the rack
"Locating the
"Shutting down the
59.
107