Verifying And Configuring The Backup Software Solution - Fujitsu PRIMERGY BX924 S3 Upgrade And Maintenance Manual

I
Up to two Option ROMs can be activated in the system board BIOS
at a time.
For detailed information on how to access the BIOS and modify
settings, refer to the "D3143 BIOS Setup Utility for PRIMERGY
BX924 S3" reference manual.
Ê From the Advanced menu select Option ROM Configuration. When iSCSI is
used via an Onboard CNA, From the Advanced menu select Onboard
Devices Configuration - Onboard CNA OpROM.
When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the
expansion card's firmware.
Ê Press the displayed key combination.
Ê Modify the expansion card firmware options as desired.
Ê Save your changes and exit the firmware.
I
The expansion card's option ROM can now be disabled in the system
board BIOS.
Exception: If the expansion card controls a permanent boot device, the
card's Option ROM has to remain enabled.
5.2.6 Verifying and configuring the backup software
solution
I
This task only applies to the Japanese market.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
This is the case for the following backup software solutions:
– Netvault for Windows
– ARCServe
– BackupExec
BX924 S3
Upgrade and Maintenance Manual
Basic software procedures
89