Konica Minolta 7022 Instruction Manual page 85

2.
Set copy conditions, as desired.
The initial settings in Interrupt mode are as follows.
Copy Mode : 1
RADF : ON
AE : ON
Lens Mode : 1.00 (100%)
APS : ON
Print Quantity : 1
Finisher : Exit Tray 1 in Sort mode
Remove any document from the platen glass or from the document feeder, if
present.
3.
Position original(s).
See p. 3-2 to p. 3-6 for details on positioning originals.
4.
Press [START] to start the interrupt copying.
When [CHECK] is pressed during Interrupt copying, the information
displayed reflects the initial copy job settings. Check mode will not display
Interrupt copy job information.
5.
When Interrupt copying is completed, press [INTERRUPT] again.
The [INTERRUPT] LED turns out and the INTERRUPT indicator on the Basic Screen
returns to the SETTING indicator.
The settings of the initial job will be restored on the Basic Screen.
6.
Press [START] to resume copying.
When the finisher / paper exit / inner tray capacity is exceeded
due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
1
a
DETAILS
HINT
DETAILS
CAUTION
Interrupt Copying (continued)
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Using
Memory
Output without
Finisher
FS-107
Output Modes
IT-101
Output Modes
Check Mode
& Proof Copy
Interrupt
Mode
3-39