Konica Minolta 7022 Instruction Manual page 190

Overlaying an Image onto Each Page Copied in the Job (Overlay) (continued)
3.
Touch OVERLAY.
4.
Touch OK on the Stamp/Overlay Selection Screen.
The Application Selection Screen will be restored.
The Store mode is automatically selected.
5.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
6.
Select the desired paper size and magnification on the Basic Screen.
APS and AMS are automatically released, and 1.00 (100%) is selected as a
magnification ratio.
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
8.
Position the overlaying original.
Position the original FACE UP in the document feeder or FACE DOWN on the platen
glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
9.
Touch SCAN on the Basic Screen.
The original image will be scanned into memory.
10.
Position the original(s) to be overlaid.
Position the original FACE UP in the document feeder or FACE DOWN on the platen
glass.
11.
Touch SCAN to scan.
12.
Repeat steps 10 and 11 for all originals.
13.
Press [START] to print.
When the finisher / paper exit / inner tray capacity is exceeded
due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
8-64
HINT
HINT
CAUTION