Konica Minolta 7022 Instruction Manual page 183

Erasing Outside of the Original (Non-Image Area Erase) (continued)
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select magnification and copy size, as desired.
• APS and AMS are automatically released.
• Copy mode is automatically set to 1
Platen store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
DO NOT CLOSE THE DOCUMENT FEEDER.
Original size should be larger than 10mm x 10mm.
7.
Press [START].
The Non-image area erase has two modes; Rectangle erase mode and
Oblique erase mode. The copier is initially set to Oblique erase mode.
If copy result is not satisfactory in the initial setting, ask Key Operator to
select the Rectangle erase mode, or to specify the original density level to
obtain the optimum copy effect. See p. 11-14.
This function may perform incorrectly if the lighting is directly over the platen
glass. In this case, consult your service representative about an appropriate
place for installation.
DETAILS
HINT
Reminder!
DETAILS: Oblique Erase and Rectangle Erase Modes
Oblique erase mode
DETAILS
1 . When selecting 1
a
Rectangle erase mode
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
2 mode,
a
Booklet
OHP
Image Insert
Dual Page
Mixed
Original
Folded
Original
Non-Standard
Size
Flip Side 2
Text/Photo
Enhance
Reverse
Image
Repeat
8
Applications
Frame/Fold
Erasure
AUTO
Layout
Image Shift
Reduce &
Shift
Non-Image
Area Erase
Stamp
Overlay
8-57