Konica Minolta 7022 Instruction Manual page 176

Copying Image in the Centre of Copy Paper (AUTO Layout) (continued)
• Non-Image Area Erase will be selected automatically.
• When using the Dual Page with this function, the original smaller than the
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic Screen.
• APS and AMS are automatically released, and 1.00 (100%) is selected
• Copy mode is automatically set to 1
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original(s) FACE UP in the document feeder or FACE DOWN
on the platen glass.
For details on positioning originals, see p. 3-2 to p. 3-6.
DO NOT close the RADF when Non-Image Area Erase is selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [START].
When the finisher / paper exit / inner tray capacity is exceeded
due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if the lighting is directly
over the platen glass. In this case, consult your service representative about
an appropriate place for installation.
8-50
DETAILS
selected paper size will be printed in the centre of the copy paper without
image division performed.
DETAILS
as a magnification ratio.
Platen store mode will function automatically.
HINT
HINT
Reminder!
CAUTION
DETAILS
1 . When selecting 1
a
2 mode,
a