Konica Minolta 7022 Instruction Manual page 79

Output Mode for Machine with Finisher (continued)
5.
Select the desired staple position.
Touch to highlight the desired staple position key on the Staple Position Selection
popup menu.
STAPLE SET on this screen will change to ADD STAPLER when replace-
ment of the staple cartridge is required. See p. 10-5.
Touch OK to restore the Output Mode popup menu.
6.
Touch OK.
The Basic Screen will be restored.
The finisher mode icon (Stack: none, Sort:
staple position icon appears/diappears in the message area of the screen to
indicate the selected output mode.
7.
Select additional copy conditions, as desired.
8.
Enter the desired print quantity from the control panel keypad.
See p. 9-3~p. 9-4 to be sure that the finisher capacity is not exceeded.
9.
Position original(s).
See p. 3-2 to p. 3-6 for details on positioning originals.
10.
Press [START].
Press [STOP/CLEAR] to suspend the scanning or printing job.
When the finisher exit tray capacity is exceeded due to the print
quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
DETAILS
DETAILS
HINT
HINT
CAUTION
, Group: , Staple:
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Using
Memory
) or
Output without
Finisher
FS-107
Output Modes
IT-101
Output Modes
Check Mode
& Proof Copy
Interrupt
Mode
3-33