Konica Minolta 7022 Instruction Manual page 83

Checking Feature Selections and Proof Copying (continued)
4.
If any setting change is required before proofcopying, touch EXIT to
return to the Basic Screen, then change settings, as required.
5.
Touch PROOF COPY on the Check Screen.
A sample copy will be output.
• Press [STOP/CLEAR] to suspend the proof copying. In this case, the
scanned image data will not be deleted from memory.
• You can change selections with an asterisk (*) displayed on the left side
after proof copying.
If the copy result is satisfactory, proceed to step 7.
If any setting change is required, proceed to the next step.
If the desired selection cannot be changed, press [STOP/CLEAR] to delete
all the data in memory, then press [AUTO RESET] to restart the job setting.
6.
Touch EXIT (or press [CHECK]) to return to the Basic Screen.
Change the settings, as required.
7.
Change the print quantity, as required.
Proof copy can be performed as needed, until the print quantity amount on
the Basic Screen reaches zero.
If required, change the print quantity on the Basic Screen.
8.
Press [START].
If the print quantity is not changed, the copier will output the rest, except the sample
sets.
When the finisher / paper exit / inner tray capacity is exceeded
due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
DETAILS
DETAILS
DETAILS
CAUTION
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Using
Memory
Output without
Finisher
FS-107
Output Modes
IT-101
Output Modes
Check Mode
& Proof Copy
Interrupt
Mode
3-37