Stacker/Stapler (Imfs): Replace The Staple Cartridge - Oce VarioPrint 6000 User Manual Operating Information

Stacker/stapler (iMFS): Replace the staple cartridge

Stacker/stapler (iMFS): Replace the staple cartridge
Introduction
The optional stacker/stapler (see
can put 1 or 2 staples into a document. This section describes how to replace the staple
cartridge.
Note:
Only use staples of type S36.
Replace the staple cartridge
Open the front side of the stacker/stapler.
1.
Pull the metal staple unit that contains the staple cartridge towards you.
2.
Push and hold the little amber lever to the left to unlock the staple unit.
3.
Pull the white, right-hand side of the staple unit towards you, at an angle of 90 degrees.
4.
Hold the little metal ridge at the top of the staple unit to prevent that the staple unit
5.
slides to the front.
Take the staple cartridge from the holder and insert a new staple cartridge.
6.
Push the little amber lever to the left to move the staple unit up again.
7.
Close the front side of the stacker/stapler.
8.
246 Chapter 7 - Keeping the printer running
'The output locations' on page 33) contains 1 stapler that