Instructions for printing to the stacker/stapler (iMFS)
Introduction
Note:
This section only applies to the use of oriented media and tab sheets in combination
with the optional stacker/stapler (iMFS).
The machine supports oriented media. Oriented media are media of which the front side
differs from the back side. An example of oriented media is media with a company logo.
If you use oriented media and print to the optional stacker/stapler, you must place the
media into the paper trays as follows:
•
Face up and header down (for long-edge feed)
The face of the media, for example a company logo, is visible and point towards the
front of the printer.
•
Face up and header to the left (for short-edge feed).
The face of the media is visible and points towards the left-hand side of the printer.
This orientation makes sure that the documents are stapled at the correct position.
Special instructions for the use of oriented media
When a job contains oriented media but no tab sheets, you must put this media header
down into the paper tray. The media must align with the header-down orientation of the
printed images (header down for long-edge feed and header to the right for short-edge
feed).
Special instructions for the use of tab sheets
When a job contains tab sheets, you must do the following.
•
Put all the oriented media for the job, including the tab sheets, header up and header
to the left (for short-edge feed) into the paper tray.
•
Temporarily change the default media orientation on the Controller to 'Header-up'.
To do this, you must go to the setting 'Preferences' - 'Print job defaults' - 'Stacker/sta-
pler (iMFS)' or 'Stacker/stapler upper output' - 'Header orientation'. There you can
click the radio button for 'Header-up'.
Jobs that contain tab sheets are sent to the stacker/stapler when no stacker is present.
When a stacker is present, the jobs are sent to the stacker to improve the stack quality.
Instructions for printing to the stacker/stapler (iMFS)
Chapter 5 - Working with the operator panel
51