Change The Number Of Staples - Oce VarioPrint 6000 User Manual Operating Information

Change the number of staples

Change the number of staples
Introduction
When a job is sent to the machine, a desired number of staples for that job can be indi-
cated. However, you can change the number of staples on the operator panel.
This section describes how to change the number of staples for a specific job.
Note:
There must be a match between the selected output location and the job requirements.
For example, when a job does not require staples, you can select any output location.
When a job requires 1 or 2 staples, you can only select the output locations that can
staple the jobs, for example 'Finisher' because the 'Stacker' cannot staple the jobs. If you
make a combination that is not possible, the operator panel displays an error message.
Change the number of staples
On the operator panel, press the 'Jobs' button.
1.
In the list of 'Waiting jobs' or 'Scheduled jobs', touch the job you want to edit.
2.
Press 'Properties'.
3.
Note:
You can also press the job 2 times to access the 'Properties' window. This function is
comparable to double-clicking with a mouse.
Touch the 'Binding' button.
4.
Touch the desired number of staples.
5.
Touch the desired location of the staples.
6.
Press 'OK'.
7.
The 'Binding' button shows the currently selected number of staples.
90 Chapter 5 - Working with the operator panel