Lubricate the die sets
Introduction
The die sets have a life expectancy of approximately 500,000 punched sheets. However,
when you lubricate the die sets on a regular basis, the life expectancy can increase. You
must regularly lubricate the following parts.
•
The punch pins.
•
The shoulder bolts and springs.
•
The felt oil pad, if applicable.
Some die sets have a felt oil pad that must be lubricated. The following table indicates
which types of die set do or do not have a felt oil pad.
Types of die sets with and without a felt pad
Type
1
2
3
When to do
•
Lubricate the punch pins every 50,000 punched sheets.
•
Lubricate the shoulder bolts and springs every 200,000 punched sheets.
Required tool
•
Use a high quality machine oil to lubricate the die sets.
Caution:
Do not use an aerosol (spray) type of oil. This type of oil leaves a sticky residue on the
pins and attracts paper dust.
Note:
See
'Replace a die set' on page 189
set into the die set slot.
Description
No felt oil pad
A felt oil pad on 1 side, includ-
ing a magnet and retaining plate
A felt oil pad surrounds the
punch pins
for information about how to remove and insert a die
Chapter 6 - Optional finishers and other devices
#
Die sets
2-, 3-, 4-Hole and VeloBind
02:01 AM and 03:01 AM Wire
(round and square holes)
19-, 20-, 21-Hole comb
44-, 47-Hole coil
Lubricate the die sets
®
193