Stop A Job - Oce VarioPrint 6000 User Manual Operating Information

Stop a job

Stop a job
Introduction
When the machine is printing a job, you can stop the machine at the following moments.
•
Stop after a set
•
Stop after a page
• Stop after a job.
The following table gives an overview of the stop behavior of the machine. The procedures
in this section describe how to stop the machine via the operator panel.
Note:
You can also interrupt a job by ejecting a stack of sheets from the stacker. When you
press the eject button next to the stacker door 1 time, the stacker ejects the stack when
a set is ready. When you press the eject button 2 times, the stacker ejects the stack as
soon as possible.
The stop behavior of the machine
When does the machine stop
When
You press the Hold key
You press the Hold key
You touch the 'Stop after job' button in
the toolbar of the 'Jobs' view
52 Chapter 5 - Working with the operator panel
#
Then
1 time The machine stops when a set of the ac-
tive print job
the set size and the moment you press the
key, when the machine will stop. For ex-
ample, when you have a large set of 1,000
pages and you press the key after the first
page, the printing will continue for a
couple of minutes.
2 times The machine stops as soon as possible
(after a page, in most cases within 30
seconds).
The machine stops when the selected job
is ready.
The 'Jobs' view displays a horizontal red
and white stop bar below the selected job.
The 'Schedule' view displays a vertical
stop bar behind the selected job.
is ready. It depends on