Service information
Inspect the die sets
Introduction
Die sets have a life expectancy of approximately 500,000 punched sheets. The life expectan-
cy depends partially on the used media types. The life expectancy of the die sets can in-
crease, for example:
•
When you observe the lubrication schedule (see
•
When you punch the same media type most of the time.
•
When you punch less cover stocks.
You must periodically inspect the die sets for wear. The result of the inspection can be
one of the following.
•
The die set is not worn. You can continue to use the die set.
•
The die set shows signs of wear. You must replace the die set.
Note:
When a die set reaches the end of life, the die set can cause paper jams.
When to do
Inspect the die sets after 500,000 punched sheets and consequently each time you lubricate
the die sets.
Note:
See
'Replace a die set' on page 189
set into the die set slot.
Illustration
[117] Inspect the die sets
'Lubricate the die sets' on page
for information about how to remove and insert a die
Chapter 6 - Optional finishers and other devices
Inspect the die sets
193).
191