Finisher: Add staples
Finisher: Add staples
Introduction
The optional finisher
your jobs. The finisher contains 2 staplers. Both staplers are located inside the finisher.
Stapler 1 is located at the back side. Stapler 2 is located at the front side.
This section describes how to add staples.
When to do
When a staple cartridge is empty or almost empty
on page
111.
Note:
You can add short and long staples. It is important to add the correct staples. Use short
staples when your documents contain up to 50 sheets. Use long staples when your doc-
uments contain more than 50 sheets. Only use staples of type S25 (long staples) or S37
(short staples).
Get access to the staplers
Open the front door of the finisher.
1.
Open top cover E1.
2.
Open cover E5.
3.
Lock cover E5 with the locking mechanism E6.
4.
If required, slide stapler 1 to the center. This makes the access to the cartridge holder in
5.
stapler 1 easier.
Add staples
Remove the cartridge holder from the stapler.
1.
240
Chapter 7 - Keeping the printer running
'The output locations' on page 33
on top of the stacker can staple
'Check the status of the staple cartridges'