Activate The Hotfolder Function - Oce VarioPrint 6000 User Manual Operating Information

Activate the hotfolder function

Activate the hotfolder function
Introduction
The information in this section is intended for system administrators.
Note:
By factory default, the hotfolder function is disabled. To use the hotfolder function, the
system administrator must activate this function once. After the system administrator
activated the hotfolder function, up to 10 hotfolders can be defined.
Note:
For this procedure, the System administrator password is required.
How to activate the hotfolder function
Open the web browser and enter the host name or IP address of your PRISMAsync
1.
controller.
Go to the 'Workflow' -> 'Hotfolders' section.
2.
Click 'Configure'.
3.
At 'Enabled', select 'Yes' to activate the hotfolder function.
4.
Enter a unique 'User name' and 'Password'.
5.
Make sure that you filled in the user name and password before you continue with the
next step.
Click 'OK' to confirm the activation of the hotfolder function.
6.
A confirmation window opens.
Click 'OK' to restart the controller now.
7.
•
Introduction to hotfolders, on page 101
•
Create a hotfolder, on page 103
•
Create a shared network folder on a workstation, on page 104
102 Chapter 5 - Working with the operator panel