Change The Warning Time - Oce VarioPrint 6000 User Manual Operating Information

Change the warning time

Change the warning time
Introduction
When operator interaction is required now or soon, the dashboard (see
on page 40) can display a warning message. The message informs you about a required
upcoming action, for example load a required media type or empty an output location.
You can define how long in advance the warning message is displayed. By factory default,
the function 'Warning in advance' is enabled and set to 10 minutes. Then the dashboard
starts to display the warning 10 minutes before an action becomes inevitable. If you do
not respond to the warning message, the printer will stop. Depending on the urgency of
the warning message, the vertical bar in the dashboard is orange or red.
This section describes how to change the warning time. This section also describes how
to disable the function 'Warning in advance', in case you do not want to use the warning
function.
Note:
The operator attention light (see
the status of the machine. For example, when the dashboard displays an orange warning,
the orange light of the operator attention light also lights up.
Set the warning time
On the operator panel, press the 'System' button.
1.
Press 'Setup'.
2.
Touch the 'Warning time' button in the 'User interface' section.
3.
Touch the - or + button to decrease or increase the warning time.
4.
You can set a time from 1 - 60 minutes.
Press 'OK'.
5.
Disable the warning time
On the operator panel, press the 'System' button.
1.
Press 'Setup'.
2.
Touch the 'Warning time' button in the 'User interface' section.
3.
A dialog box appears. When the 'Warning in advance' function is enabled, the 'Warning
in advance' button displays a check mark and the status 'On'.
Touch the 'Warning in advance' button.
4.
The check mark disappears. The status 'On' changes into 'Off'.
Press 'OK'.
5.
128 Chapter 5 - Working with the operator panel
'The operator attention light' on page
'The dashboard'
31) is linked to