Restoring Announcements - Avaya Communication Manager Administrator's Manual

Restoring Announcements

Note:
This task only applies if you are using a TN750-series announcement circuit
Note:
pack.
If you are using the TN2501AP (VAL) announcement circuit pack or VVAL
announcements, see
LAN device
You can restore announcements from system memory to an announcement circuit pack. Your
system memory is a tape, disk, or memory card, depending on your system.
If you have a duplicated system, you system always restores the announcements located on
the active processor.
We will restore announcements from our system memory (stored on a disk) to the integrated
announcement circuit pack on our system.
To restore announcements from system memory to the integrated announcement circuit pack:
1. Type restore announcements disk and press Enter.
We will restore announcements from system memory to an announcement circuit pack that has
built-in memory. We know that the announcement circuit pack is located at 01B18:
1. Type restore announcements from cabinet 01. carrier B, slot 18 and
press Enter.
2. Press Enter to restore announcements.
Fixing problems
Problem
You receive error
code E28
You receive error
code E31
If the system crashes or there is a processor interchange during restore announcements, the
restore fails and there is no valid announcement on the circuit pack. Repeat the process when
the system is operating properly.
Moving announcements to a VAL circuit pack or to another
on page 477.
Possible causes and solutions
You do not have an integrated announcement circuit pack in the
system.
A call is connected to the announcement on the circuit pack and
the port is busy. Wait for the call to disconnect and try restore
announcements again.
Restoring Announcements
Issue 1 June 2005 461