Avaya Communication Manager Administrator's Manual page 329

ESM T.120 Server Administration
Figure 149: DS1 Circuit Pack screen
change ds1 1c09
Signaling Mode: isdn-pri
MMI Cabling Board: 01C10
Slip Detection? n
From the system administration terminal:
1. Type list configuration all, and a list of the installed carriers, circuit packs, and
ports appears.
2. Record the location (board number) of the MMI board cabled to the TN2207 slot and verify
that all other required circuit packs are present.
3. Enter add DS1 xxxxx, (where xxxxx is the location of the TN2207 PRI circuit pack
recorded in step 2), and the DS1 Circuit Pack administration screen appears.
4. Set the Name field to ESM DS1.
5. Set the Bit Rate field to 2.048.
The TN2207 DS1 must have a bit rate of 2.048, even if all other DS1 boards in the system
are operating at 1.544. Verify the 24/32 channel switch on the circuit pack is in the 32
channel position.
6. Set the Line Coding field to hdb3.
7. Set the Signaling Mode field to isdn-pri.
8. Set the Connect field to pbx.
9. Set the Interface field to network.
10. Set the Country Protocol field to 1.
11. Set the CRC field to y.
Location: 01C09
Bit Rate: 2.048
Connect: pbx
Idle Code: 11111111
DCP/Analog Bearer Capability: 3.1kHz
DS1 CIRCUIT PACK
Line Coding: hdb3
Interface: network
Country Protocol: 1
MMI Interface: ESM
Near-end CSU Type: other
Multimedia Call Handling
Page 1 of
Name:
CRC? y
Issue 1 June 2005
1
329