Removing Trunk Groups - Avaya Communication Manager Administrator's Manual

Removing Trunk Groups

There's more to removing a trunk group than just executing the remove trunk-group
command. If you're using Automatic Route Selection (ARS), you must remove an outgoing or
two-way trunk group from any route patterns that use it. If you've administered Trunk-Group
Night Service buttons for the trunk group on any phones, those buttons must be removed or
assigned to another trunk group.
Instructions
As an example, we will remove trunk group 5. This two-way group is used in ARS route pattern
2. In addition, a Trunk-Group Night Service button on extension 8410 points to this group.
To remove trunk group 5:
1. In the Route Pattern
If you're replacing trunk group 5 with another trunk group, just type the information for the
new trunk group over the old entries. Remember to press Enter to save your changes.
2. In the Station
for the Trunk-Group Night Service button.
Remember to press Enter to save your changes.
3. In the Trunk Group
See Adding Trunks to a Trunk Group
4. Type remove trunk-group 5 and press Enter.
The Trunk Group
5. Press Enter to remove the trunk group.
screen for route pattern 2, clear the entries for trunk group 5.
screen for extension 8410, clear the entry in the Button Assignments field
screen for trunk group 5, remove all member trunks from the group.
screen appears.
on page 439 for instructions.
Removing Trunk Groups
Issue 1 June 2005 441