Transmission Features; Stamp - Savin 2018 Operating Instructions Manual

Kir-C2-ENcombine_F_FM.book Page 29 Friday, September 19, 2003 3:03 PM

Transmission Features

Stamp

The optional ADF or ARDF is required.
When sending a fax message using
the ADF or ARDF, the machine can
stamp a circle mark at the bottom of
the original. When sending a two-sid-
e d d o c u m e n t , t h e d o c u m e n t i s
marked at the bottom of the front
page and top of the rear page. This
stamp indicates that the original has
been successfully stored in memory
for Memory Transmission, or suc-
cessfully sent by Immediate Trans-
mission.
Note
❒ Stamp only works when scanning
from the ADF or ARDF.
❒ The
stamp
grammed to the User Function key
{ { { { F3} } } } by default. If you change it to
another function key, you need to
press that key. If you do not pro-
gram the stamp function in a User
Function key, you cannot use the
stamp function. For details about
User Function key registration, see
p.72 "General Settings/Adjust".
function is pro-
Transmission Features
❒ When the stamp starts getting
lighter, replace the cartridge. See
p.105 "Replacing the Stamp Car-
tridge".
❒ If a page was not stamped even
though the Stamp function is
turned on, you need to resend that
page.
❒ A paper jam during Parallel Mem-
ory Transmission may cause the
transmission to be failed even if
stamping is performed.
❒ You cannot turn the Stamp func-
tion on or off while a document is
being scanned.
A A A A
Place the original, and then select
the scan settings you require.
Reference
p.15 "Placing Originals", Fac-
simile Reference <Basic Features>
p.29 "Scan Settings", Facsimile
Reference <Basic Features>
B B B B
Press the User Function key { { { { F3} } } }
to light the Stamp indicator.
g
Immediate
Trance.
Start Manual Memory
Reception
Trance.
Switch
RX Mode
Standard
Detail
Transmission
Fine
Stamp
Note
❒ To cancel the stamp, press the
User Function key { { { { F3} } } } again.
3
ABC DEF
05 06 0
MNO PQR
09 10 1
@. _
_
YZ @. _
13 14 15
Shift Space S
AAN124F
29