Installing The Guide Bar; Break-In Operation - JUKI AP-876/IP-420 Instruction Manual

3-14. Installing the guide bar

3-15. Break-in operation

B
1） Display the main motor revolutions check screen.
Press the
A appears on the screen. Press this button to display the
main motor revolutions check screen.
A
2） Run the main motor to break in the machine.
It is possible to set the number of revolutions by means of + and
－ buttons
Press the
C
tions you have set.
At this time, the number of revolutions measured by the machine
D
is displayed on
E
Press reset button
Set the number of revolutions for the break-in operation at 2000.
To use a new machine or the machine after an extended
time of disuse, be sure to run in the machine for approxi-
mately 30 seconds to one minutes.
12
－
Securely insert the thread guide bar into the hole in the
top cover in the orientation as shown in the figure at the
left.
key. The main motor revolutions check button
B and C .
key to run the machine at the number of revolu-
D .
E to stop the sewing machine.
－