Installing / Removing The Bobbin Case; Setting A Bobbin Into The Bobbin Case - JUKI AP-876/IP-420 Instruction Manual

4-3. Installing / removing the bobbin case

WarNING :
turn oFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine
2

4-4. Setting a bobbin into the bobbin case

B
C
D
1
A
5
－
) Fully rase latch 2 of bobbn case 1 untl t stops,
and take the bobbn case out of the hook. The bob-
bn ftted n bobbn case 1 wll not come off the
bobbn case by holdng latch 2 with fingers.
2) To nstall the bobbn case n the hook, be sure to
rase latch 2 and fully fit the bobbin case over the
hook drvng shaft. Then release latch 2 to let t
down.
Please use the accessory exclusive
bobbin case. also, if it is not pushed in
far enough, bobbin case 1 might fall
out during sewing. So, be careful.
) Hold the bobbn n a way that the thread open end
s drected to the rght as observed from you, and
set the bobbn nto the bobbn case.
2) Pass the thread through thread slt A , and pull the
thread n drecton B . By so dong, the thread wll
pass under the thread tenson sprng and come out
from notch C .
3) Check that the bobbn rotates n the drecton of the
arrow when bobbn thread D s pulled.
－