JUKI AP-876/IP-420 Instruction Manual page 50

Example) In the case BLADE button
I
J
Foldng tmng nput screen for
the blade shape
Example) In the case NO PATTERN
SELEctIoN button
pressed
I
J
K
L
N
M
Foldng tmng nput screen for the
case no pattern type s selected
a
Q
B
Foldng tmng nput screen
D is pressed
3 Select the folding blade timing for which is to be set.
O
When ON/OFF TIMING SETTING button I , J , K , L , M
or N s pressed, the ON/OFF tmng settng screen for the
N
blade whch corresponds to the locaton ndcated by the
button.
L
FOLDING BLADE A ON/OFF
K
I
TIMING SETTING button
FOLDING BLADE A2 ON/OFF
J
TIMING SETTING button
P
FOLDING BLADE A3 ON/OFF
K
TIMING SETTING button
FOLDING BLADE A4 ON/OFF
L
TIMING SETTING button (*1)
FOLDING BLADE A5 ON/OFF
M
TIMING SETTING button (*1)
FOLDING BLADE B ON/OFF
H is
N
TIMING SETTING button (*1)
CANCEL button
O
O
SEWING SHAPE INPUT
P
button
(*1) this button may not be displayed for some sewing shapes.
4 Set the timing.
The settng tme s set by pressng numerc keypad Q . To
dsable the tmng settng, press DISUSE button
P
When you press ENTER butto
you have set s stored n memory.
The tmng at whch the
a foldng blade s turned ON
(actvated) s dsplayed
O
The tmng at whch the
foldng blade s turned
B
OFF (returned to ts home
poston) s dsplayed
Numerc keypad
R Q
U
S + button
R
－ button
S
T
ENTER button
T
(*2) a set value can be input in increments of 0.01 sec by means of
the numeric keypad. When the set value is recorded by means
of the ENtEr key, the value is rounded down to 0.00 when the
first decimal plate is less than 0.05 or rounded down to 0.05
when it is in the range from 0.06 to 0.09.
– 46 –
Name
The foldng blade A ON/OFF
tmng settng screen s dsplayed.
The foldng blade A2 ON/OFF
tmng settng screen s dsplayed.
The foldng blade A3 ON/OFF
tmng settng screen s dsplayed.
The foldng blade A4 ON/OFF
tmng settng screen s dsplayed.
The foldng blade A5 ON/OFF
tmng settng screen s dsplayed.
The foldng blade B ON/OFF
tmng settng screen s dsplayed.
The screen s returned to the
prevous screen.
The sewng shape nput screen s
dsplayed to allow the change of
the sewng shape.
Name
It represents the watng tme (n
seconds) from the start of foldng to
the actvaton of the cylnder.
It represents the watng tme (n
seconds) from the end of foldng to
the return of the cylnder.
Ths button can be used to nput data
wthn the range from 0.00 to 9.95. (*2)
Ths button s used to ncrease the
set value n ncrements of 0.05 (sec).
Ths button s used to decrease the
set value n ncrements of 0.05 (sec).
This button is used to confirm the
nput value and close the screen.
Function overview
U .
T , the numerc value
Function overview