Adjusting The Signal For Each Track (Track Parameters) - Zoom MRS-1608 Operation Manual

Reference [Mixer]
NOTE
• The diagrams above show the signal flow when the insert
effect has not been inserted into the input mixer. When the
insert effect is inserted, the signal flow will change, depending
on the number of input and output channels of the effect
→
( p. 141).
• In 8-track recording mode (
1 – 8 are sent to tracks 1 – 8.
HINT
• When no recording track is selected, the input signals are sent
directly to the [MASTER] fader. The pan controls of the input
mixer can be used to adjust the panning value of the signal
sent to the [MASTER] fader. (When a recording track is
selected, the pan setting of the input mixer has no effect on
the signal.)
• By using the bounce function, you can apply the send/return
effect to the input signal for recording (
Adjusting the signal for each
track (track parameters)
The input mixer and track mixer let you adjust various
aspects for each track (called track parameters), such as
panning and send/return effect intensity. This section
describes how to adjust track parameters.
1.
Press any key in the track parameter
section.
Pressing any of the keys in the track parameter section
brings up the respective track parameter on the display.
The keys that are active for the target track/input light up.
Keys for inactive parameters and for parameters not
included in that track/input are out.
2.
Use the cursor left/right keys or the status
keys and [ON/OFF] keys to select the track/
input.
HINT
• To select a single track from a pair of stereo tracks (such as
track 9 or track 10), press the status key repeatedly.
• In 8-track recording mode, eight inputs can be used
simultaneously. In this case, you can select the input with the
respective [ON/OFF] key and adjust track parameters for each
input (except for the record level). The display will show the
number of the input (INPUT 1, INPUT 7, etc.)
80
→
p. 45), the signals from inputs
→
p. 42).
3.
Use the cursor up/down keys to select the
track parameter you want to adjust. For a
list of available parameters, see the table
on the next page.
For track parameters which have dedicated keys, you can
select the parameter directly by pressing the key.
4.
Turn the dial to adjust the value.
5.
For parameters where on/off can be
selected (marked with an asterisk in the
table on the next page), repeatedly press
the respective key in the track parameter
section until the key is out.
Each push of the key toggles between lit (on) and out
(off).
For example, when switching high-range EQ from on to
off, the display indication changes as follows. Pressing
the respective key once more restores the previous
condition.
• On condition
TR1 TR1
EQ HI G G EQ HI
• Off condition
TR1 TR1
EQ HI EQ HI
6.
Repeat steps 3 – 5 until all desired
parameters are adjusted.
If required, you can use the cursor left/right keys, status
keys and [ON/OFF] keys in this condition to change to
another track/input and adjust other parameters.
7.
To return to the main screen, press the
[EXIT] key.
0dB 0dB
OFF OFF
ZOOM MRS-1608