Importing Part Of A Track/V-Take - Zoom MRS-1608 Operation Manual

SAMPLE SAMPLE
IMPORT IMPORT
6.
Verify that "SAMPLE IMPORT" is shown on
the display and press the [ENTER] key.
You can now select the type of import source.
IMPORT IMPORT
TAKE TAKE
7.
Use the cursor left/right keys to select one
of the following, and press the [ENTER] key.
●
TAKE
Import a specified range of audio data from any track/V-
take in the currently loaded project.
●
WAV/AIFF
Import an audio file (WAV/AIFF) from a CD-ROM/R/
RW disc inserted in the CD-R/RW drive or from the
internal hard disk.
The subsequent steps differ, depending on which
selection was made. For details, see the respective
section.
When the import process is completed, the sample
selection screen appears again. If necessary, import more
samples. The maximum number of samples that can be
imported is 1000.
To return to the main screen, press the [EXIT] key several
times.
HINT
The imported samples are automatically assigned a name,
using the pattern "SAMPLxxx" (where xxx is the sample
number).

Importing part of a track/V-take

You can specify a range on any track/V-take in the
currently loaded project and import this as a sample.
1.
Refer to steps 1 – 7 of "Basic steps for
sample importing" to bring the indication
"TAKE" onto the display. Then press the
[ENTER] key.
ZOOM MRS-1608
The display now shows "ImprtSrc TR xx-yy" (where xx
is the track number and yy the V-take number). In this
condition, you can select the track/V-take to use as import
source.
2.
Use the dial or the status keys to select the
track, and use the cursor up/down keys to
select the V-take.
ImprtSrc ImprtSrc
TR 16- 1 TR 16- 1
When track 16 is selected, turning the dial further to the
right lets you select odd/even track pairs or the master
track. If you press the adjacent status keys of an odd-
numbered and even-numbered track in succession,
"mono track x 2" is selected.
HINT
Repeatedly pressing the status keys for stereo tracks selects
the odd-numbered track, even-numbered track, and stereo
track in sequence.
3.
Press the [ENTER] key.
The display now shows "ImprtSrc START". This lets you
specify the import start position.
ImprtSrc ImprtSrc
START START
0 0 0 0 0 0 0 001
4.
Use the cursor left/right keys to move the
flashing section of the counter, and turn the
dial to specify the import start point.
By moving the flashing section to the MEASURE/BEAT/
TICK or MARKER field on the display, you can specify
the point as a measure, beat, tick, or as a mark number.
HINT
• By holding down the STOP [P] key and pressing the PLAY
[R] key, you can perform scrub playback of the specified
→
range ( p. 38).
• The sample playback range can be fine-tuned also after
importing.
• If you specify a point where there are no audio data, the
second line of the display
Reference [Pad Sampler]
001 1 1 0 0 00 00
shows symbol
.
123