Zoom MRS-1608 Operation Manual page 107

precedence over other formulas.
For example, entering 0 + (1 + 2) x 2 + 3
following rhythm pattern play sequence.
PATTERN 0 PATTERN 1
PATTERN 1 PATTERN 2
An example for creating the rhythm pattern sequence
(0 + 1) x 4 + 2 is shown below.
ZOOM MRS-1608
will result in the
PATTERN 2
PATTERN 3
(
(0 (0
(0+ (0+
(0+1 (0+1
(0+1) (0+1)
(0+1)x (0+1)x
(0+1)x4 (0+1)x4
(0+1)x4+ (0+1)x4+
(0+1)x4+ (0+1)x4+
2
HINT
• If the formula does not fit on two lines, the indication scrolls
by one character each. If you use the cursor left/right keys to
move the input position, the line scrolls left and right
accordingly.
• For FAST input, leading zeros are omitted. For example,
pattern 001 is shown as "1", and pattern 050 as "50".
• The formula entered with FAST input is saved as part of a
project. By calling up the formula later, you can edit it or use it
to write the song.
NOTE
• The FAST method can only write a song in one go, from
beginning to end. Entering rhythm patterns partly into the
song is not possible.
• To edit a rhythm song that was written with this method, edit
the formula and then write the entire song again, or use step
input.
1.
Press the [SONG] key and then the
[RHYTHM] key to switch the rhythm section
to rhythm song mode.
2.
Press the [EDIT] key.
The rhythm song mode edit menu appears.
3.
Use the cursor left/right keys to bring up
the indication "EDIT FAST" on the display,
and press the [ENTER] key.
FAST input is now possible.
4.
Use the keys and pads of the rhythm
section to enter the formula for creating the
rhythm song.
Formula input principles are explained on page 106.
(0+1)x4+ (0+1)x4+
2
If you make a mistake during input, correct it as follows.
●
Inserting a number/formula
Use the cursor left/right keys to move the flashing
section, and enter the new numeral or symbol.
●
Deleting a number/formula
Use the cursor left/right keys to cause the numeral or
symbol that you want to delete to flash, and press the
[DELETE/ERASE] key.
Reference [Rhythm]
107