Zoom MRS-1608 Operation Manual page 79

When the setting is complete, press the [EXIT] key to
return to the main screen.
HINT
• With the default settings of a project, the insert effect is
inserted into the input mixer, and a patch suitable for guitar/
bass recording is selected.
• To record without sending the sound through the insert effect,
press the [BYPASS] key in the effect section to bypass the
insert effect.
5.
Press one of the [ALGORITHM] keys in the
effect section to select the desired
algorithm, and then use the PATCH SELECT
Q W
[ ]/[ ] keys or the dial to select the patch
to be used.
INSERT INSERT
MRS-DRV MRS-DRV
6.
While playing your instrument, adjust the
recording level by turning the [REC LEVEL]
control.
The [REC LEVEL] control adjusts the signal level before
it is sent to the recording track (i.e., after it has passed
through the insert effect). The [CLIP] indicator will light
if the level is too high. Set the recording level as high as
possible, but avoid settings that cause the [CLIP]
indicator to light.
HINT
• The level of the signal sent to the recording track will change
according to the settings of the insert effect parameters. If you
switch insert effect patches or edit the parameters, you
should once again check whether the recording level is
appropriate.
• The precise value of the [REC LEVEL] control parameter can
be checked by pressing any key in the track parameter
section and then pressing the cursor down key, so that the
value of "REC LVL" is shown.
7.
Repeatedly press the status key for the
recording destination track until the key is
lit in red.
The input signal from the input mixer will be sent to the
recording track. You can select record mode for up to two
mono tracks (1 – 8) or one stereo track (9/10 – 15/16).
When selecting two mono tracks, only odd/even pairs can
be selected (1/2, 3/4, 5/6, 7/8). To select two tracks,
ZOOM MRS-1608
No.0 No.0
repeatedly press the status key for one track until the key
is lit in red, and then hold the key while pressing the
status key for the other track.
The signal flow from the input mixer to the track will
change as follows, depending on the number of inputs
and recording tracks.
• Mono track selected as recording track
INPUT 1
INPUT 1
INPUT 2
• Stereo track or two mono tracks selected
as recording track
INPUT 1
INPUT 1
INPUT 2
• No track selected as recording track
INPUT 1
Track
mixer
PAN
INPUT 1
PAN
INPUT 2
Track
mixer
Reference [Mixer]
Recorder
Track
Recorder
Track
Recorder
Track
Track
Recorder
Track
Track
PAN
OUTPUT
[MASTER] fader
[MASTER] fader
L
R
79